Full-automatic folding machine is a washing machine product used for fabric folding machine. When it works, it is believed that you may encounter some common faults, such as: there is no folding after the first horizontal folding of the fabric, the machine runs, and the operation control screen reports errors. Many users do not know how to solve these faults, which brings great resistance to work. Common types of folding machines include: non-woven fabric folding machine, rag folding machine, wiping cloth folding machine, wet towel folding machine, etc. Used in laundry, hotels, hotels, hospitals, textiles, railways and other industries. Today, I will show you the common faults and solutions of industrial folding machine under Find out.

1、 The machine has no power supply (the display operation control panel has no power supply)

There are generally two reasons. Common types of folding machines include: non-woven fabric folding machine, rag folding machine, wiping cloth folding machine, wet towel folding machine, etc. Used in laundry, hotels, hotels, hospitals, textiles, railways and other industries. First, there may be a problem with the power cord. Use a stylus to check out the power cord and replace it where it is broken. Second, it may be that the fuse on the power switch is burnt out, and the fuse wire can be replaced directly.

2、 Machine does not run, operation control alarm display

In one case, the emergency stop button is turned on. Just reset the emergency stop button. In another case, the safety cover is opened. Close the safety cover and the problem will be solved.

3、 Machine operation, operation screen alarm display

It is usually caused by motor overload. Check the air switch and frequency converter, and remove and reset the faulty one.

4、 There is blockage at the cross part

Patrol to check whether there is fabric blocking at the cross folding position, eliminate and reset, and the alarm will be canceled

5、 Photoelectric switch failure

Check each photoelectric switch (k ā i gu ā n) Whether the position of the is correct or damaged (s ǔ N hu à i), adjust or replace, and the alarm will be canceled (Cancel)

6、 After the first horizontal fold, the fabric does not fold

If it is a function switch (k ā i gu ā n) If the selection is incorrect, adjust the function switch. Non-woven fabric folding machine is a kind of finishing equipment in industrial washing machinery. If the blowing solenoid valve is not opened, open the solenoid valve. If the fabric exceeds the maximum folding range (f à n w é i) or is less than the minimum folding range. Check whether the fabric is laid flat during ironing, and whether there is accumulation and size reduction when the fabric enters the front operating platform of the folding machine. If the speed of folding machine and ironing machine does not match, adjust the speed of folding machine and ironing machine.

7、 The fabric is folded for the second time without folding

If the program parameters are incorrect, you can only write the program parameters from scratch. If the fabric is too thick, too thin or too heavy, it is not recommended to iron these fabrics.

8、 The second cross folding (meaning: folding a part of the object) is not suitable. Because the height of the first cross folding knife is too deep, it is necessary to adjust the height of the first cross folding knife to not exceed the axis of the roller. In addition, adjust the cylinder pressure that controls the compaction force of the swing roller. If the blowpipe bracket is too low, then adjust the height of the blowpipe bracket so that the fabric does not fall on the bracket.

9、 The third cross folding (meaning: folding part of the object) is unqualified

If the cylinder (compressed air) and mechanical action of the third cross folding knife are not flexible, check the installation（ ā n zhu ā Ng) The two sides of the centripetal joint shaft (Shaft) bearing in the folding knife interfere with the side plate, if any, install flat pads on both sides. If the belt is loose, tension the belt. The problem is that the distance between the two belts rotating in opposite directions is too small or too large, so adjust the distance between the two belts.